Use and Care Guide

1.7 PROJECT CONDITIONS
A. Environmental Requirements:
1. Do not apply outdoors in rain or when rain is expected within 24 hours. Do not apply
above 90 degrees F (32 degrees C) or below 50 degrees F (10 degrees C) or when
temperatures are expected to fall below 40 degrees F (4 degrees C) within 24 hours.
PART 2 - PRODUCTS
2.1 MANUFACTURERS
A. Subject to compliance with requirements, provide products from the following manufacturer:
1. United Gilsonite Laboratories (UGL), which is located at 1396 Jefferson Avenue, P.O.
Box 70 Scranton, PA 18501; Customer Service: 1-800-845-5227 or 1-570-344-1202;
Email: [e-mail]; Website: www.ugl.com
B. Substitutions: Not Permitted.
C. Specifications and Drawings are based on manufacturer's proprietary literature from United
Gilsonite Laboratories (UGL).
D. Single Source Limitation for Complete System: Obtain materials from a single manufacturer to
create a complete system.
2.2 MATERIALS
A. Water based cleaner and degreaser for concrete surfaces.
1. Acceptable Product:
a. DRYLOK
®
Concrete Cleaner and Degreaser.
B. Latex and cement-based patch system with integrated bonding agent for concrete, brick and
mortar and masonry.
1. Acceptable Product:
a. DRYLOK
®
Concrete Patch.
C. Sulfamic Acid powder for cleaning and etching concrete, stone, tile, galvanized metal and brick,
1. Acceptable Product:
a. DRYLOK
®
Etch.
D. Fast-setting Hydraulic Cement for patching cracks and holes in masonry and anchoring metal to
masonry.
1. Acceptable Product:
a. DRYLOK
®
Fast Plug
®
Hydraulic Cement.
E. Latex Bonding Agent to adhere new concrete, stucco, stone and plaster to structurally sound
existing concrete, stone, gypsum board, hardboard and plaster.
1. Acceptable Product:
a. DRYLOK
®
Latex Bonding Agent.
F. Pre-mixed liquid for cleaning and etching concrete, stone, tile, galvanized metal and brick,
1. Acceptable Product:
a. DRYLOK
®
Liquid Etch.