User's Manual

19
IMPORTANT NOTE: THE WIRELESS SENSOR TINE SLEEVE
The tine sleeve acts as an “ON/OFF” switch when placed on the sensor. Removing it activates the sensor or turns it on.
Every time the sensor is turned off and back on, the sensor goes into a rapid transmission mode. It transmit 10 times at
10 second intervals to support pairing. Then, for 100 minutes, transmissions will be at once per minute to support the
installation. Finally, at approximately once per 10 minutes after that during regular operation.
IMPORTANT NOTE:
SAVE YOUR SETTINGS
Navigate to “S” to SAVE this
setting. Do not choose “X” until
you have saved the settings or
the sensor will not be paired.
7. Navigate to highlight [Choose Sensor] and press [Select]. This screen will be displayed.
8. The NWAs of the sensors the base station hears will be displayed one at a time next to
“NWA”. It is best to pair one sensor at a time and replace the tine sleeve when done.
9. Confirm that the NWA of the sensor you just activated is highlighted on the screen.
10. Note that the following menu choices have appeared and you can navigate to them with the
[Selection Wheel]: [S] - Save [C] - Clear [B] - Back
11. With the NWA highlighted, press [Select]. The first Zone position is reserved for assigning a
“Common Sensor” (See “Assigning Common Sensor” on next page). You can scroll through
the zone positions (1-6) to choose the zone to assign the sensor to.
(The figure to the left shows the sensor assigned as a Common Sensor and to Zone 2.)
12. Press [Select] and roll the selection wheel up to display the zone number. Press [Select].
13. Press [Select] again to assign the zone. Normally a Sensor is assigned to one zone, but a
single Sensor CAN be assigned to as many as 6 zones on a Base Station (See page 21).
14. Navigate to [S] to SAVE this setting.
15. It is recommended that you replace the tine sleeve over the tine for now.
Write the zone number on the tine sleeve to keep track of its assignment.
16. After saving, you will return to the [Manage Sensors] screen. You can [A] Add another
sensor by rotating the selection wheel until the [A] is highlighted and repeat steps 5-15.
17. If you are done pairing all of your sensors, rotate the [Selection Wheel] to the [X] in the
upper right corner of the screen and press [Select] to exit the screen.