User's Manual

!
! !
UG1000 Internet Bridge
The UG1000 Internet Bridge serves as the gateway or avenue by which all network and
sensor data is passed to the UgMO Data Base. Each Bridge contains an embedded Linux
processor. The bridge also serves as a repeater in any network and can forward data
packets toward their final destinations.
To install the Bridge, you will need a 110 Volt AC power source that is near a router or
other direct Ethernet connection. Using the supplied 5 Volt transformer, insert the
barrel connector into correct port located on the bottom of the Bridge and the two-
pronged block into the nearest 110 Volt outlet. Next, plug one end of an Ethernet cable
into a router using your WAN and the other end into the Ethernet slot located on the
bottom of the bridge. Finally, to mount the hardware you can use a screw and the keyhole
slot in the back of the bridge or simply hang the Bridge from the supplied plastic stand.
Once powered, a red LED on the front of the bridge will aluminate followed by a series of
Green LEDs as the bridge searches the area for any existing hardware or networks. The
LEDs are very helpful in determining the current state and operation of the bridge.