User manual

9
Note: If a crossed LocoNet cable (62010, 62020, 62040 or 62060) is used the polarity
is exchanged in the booster’s electric circuit. If when crossing the track isolation
between two track sections a short circuit occurs, Bit 5 of LNCV 3 can be used to
swap the track polarity (see chapter 4.2.3).
Info on the LocoNet Cables
In the crossed version pin 1 is connected with pin 6, pin 2 with pin 5 etc.
In the straight-through version the pins are wired 1:1, thus to pin 1 connected with pin
1, pin 2 with pin 2 etc.