User manual

Intellibox Basic
10
Important
!
Terminate configuration
Press E-key to write the new configuration to the Intellibox and do
a system reset.
After this all factory defaults are active.
Further options are possible in the Intellibox Basic Settings menu
(chapter 4).
1.3 Quick Guide
Use this section only as quick reference guide. Please read the
whole manual in detail in order to learn all functions and options of
the equipment.
Connecting Cables
You need a transformer with 16V AC output voltage and a minimum
output power of 52 VA. The 16V AC voltage from the transformer
and the two poles of the track are connected to the clamps of plug
#1 on the backside of the Intellibox.
Carefully check that the wires from the transformer have not been
swapped with those from the track, or that short-circuits did not
occur among the various wires of the connector!!
Connecting the device
If you insert the plug into socket 1 and turn the power on, the green
LED above the g key at the top right on the front panel of the
Intellibox, should light up after approx. 5 seconds to indicate the
ready status of the equipment.
Presets
The Intellibox has the following options preset ex factory:
Speed step display Direct reading
Throttle control AC control panel
Locomotive data format New Motorola (base data format)
Solenoid data format Motorola (base data format)
Track Gauge Driving Power H0
If these settings are correct for your layout, you can set the first
locomotive onto the track. Otherwise you should check under
“Configuration of Intellibox at Power on" or under "Basic Settings"
and make the necessary changes.
A full description of all options, as well as their operation is
described in chapters 3 and 4.
Calling up a Locomotive
• Press l key of the right or left control panel
• Enter the desired locomotive address using the numeric keys
• Confirm with E-key
Caution