User manual

Intellibox Basic

Figure 1.31

The 8 pairs of keys o

the key boar

Controlling a locomotive

A clockwise rotation of the control knob increases the speed, and an

anti-clockwise turn reduces the speed. To change the driving

direction press the control knob while the locomotive is stationary.

Switching the Light

• The f key switches the light on

• The o key switches the light off

Switching Special function

• Press one of the special function keys : ; < =

• If the [lok#/f+] and [off/+4] Key are pressed in quick succession,

on some DCC decoders you can switch functions f5 to f8 with

function keys [f1] to f4] (see chapter 5.2).

• If the [lok#/f+] and [f0/+8] Key are pressed in quick succession, on

some DCC decoders you can switch functions f9 to f12 with

function keys [f1] to f4] (see chapter 5.2).

All inputs must be made by the control panel on which the

locomotive with the desired address was called up.

Change the digital format of individual locomotives

• Place the vehicle on the track

• Press [lok#/f+] key of the right or left control panel

• Enter the desired locomotive address using the numeric keys

• Confirm input with E-key

• Press [lok#/f+] key of the same control panel

• Press m key

• With the D-key scroll to the desired data format

• Confirm input with E-key

Switching turnouts

The switching is done using the numeric keys.

Using eight pairs of keys, eight turnouts or signals

with the addresses 1 to 8 can be switched. The

position of the turnouts is indicated in the middle

part of the display.

The middle section of the display gives information about the

current status of the keyboard, with the key pair on which the upper

(red) key was pressed last (in the figure 2 and 8). The rectangular

symbol appears a little further above the other key pairs, on which

the lower (green) key was pressed last.

The allocation of the keyboard can be changed (see chapter 6.4).

Note