User manual

Intellibox Basic
20
3.2 The display
The large LCD display with backlighting shows a clearly arranged
user interface. The clear, three sectioned display provides an exact
overview of the present driving conditions for you at all times.
At the sides the display shows the used data format, locomotive
address, vehicle speed and driving direction of the currently
controlled vehicle.
The center shows information relevant to currently selected
operating mode, e.g. in keyboard mode the display of the turnout
position or signal state.
In programming mode prompting is as shown above.
The setting of contrast and brightness is done by the Basic Settings
menu (chapter 4.10).
3.3 Key functions
The [stop] key
The [stop] key is used to switch off the driving power to the mainline
and the track sections supplied by attached boosters. The display
then shows the message "Emergency Stop".
This key is used by both control panels.
The [go] key
The [go] key is used to switch on the driving power to the mainline
and the track sections supplied by attached boosters. It is used by
both control panels.
If the [go] and [stop] are pressed at the same time for approximately
two seconds, the Intellibox is reset to its start position and the whole
system reboots.
Halt status
In the "Halt State" all locomotives are brought to a halt by an
emergency stop instruction. The track is still supplied with power so
that solenoids can be changed or travel direction and speed setting
of Locomotives can still be done. In the "Halt state" one can change
incorrectly set turnouts or signals which led to an accident on the
layout.
The "Halt State" is reached as follows:
Note