User manual

Intellibox Basic
28
The default factory setting is the DCC format.
Possible settings are:
DCC 14-28-128
DCC format with 14, 28 or 128 speed steps
Motorola - old
Old Motorola data format
Loco decoder without special functions
Function decoder controlled by [f1] [f2] [f3] [f4]
Motorola - new
Also called Gauge 1 Format, with locomotive special functions f1-f4.
The digital format of each locomotive can be modified independently
of all other locomotives. Detailed instructions are given in “Changing
individual Locomotive data format” (Chap. 4.5).
How to change the loco data format
• Press the m key
• Press the M key
• Scroll with the D key until you read "Loco data format"
• Enter the menu with the R key
• Scroll with the D key until you reach your desired entry
• Select this setting by pressing the E key
• Go back to the main display with the m key
4.8 Menu “Accessory (decoder) setting”
Solenoid device decoders from Märklin, Viessmann and Modeltreno
are compatible with the Motorola format. Their addresses are
defined using the DIP switches that can be found inside each unit.
Each decoder is characterized by a unique address.
All Intellibox setup menus make use of these turnout addresses and
not the solenoid decoder address.
The appendix has a table which shows the relationship between the
DIP switch position and the turnout addresses, as well as the
allocation for that Märklin keyboard.
The data format which is automatically selected the first time a
decoder is called up is set here as long as (as described in chapter
3.5.2) the particular decoder does not use another data format.
The data format which is most frequently used should be set here
before the first use of the Intellibox.
The default is the DCC data format.
How to change the accessory (decoder) setting
• Press the m key
• Press the M key
• Scroll with the D key until you read “Access.Setting”
• Enter the menu with the R key
• Scroll with the D key until you read “General type”
Note
Attention