User manual

Intellibox Basic
29
• Enter the menu with the R key
• Scroll with the D key until you reach your desired entry
• Select this setting by pressing the E key
• Go back to the main display with the m key
Switching decoders in Motorola Format:
Uhlenbrock, Märklin, Viessmann, Modeltreno
Switching decoders in DCC Format:
Uhlenbrock, Roco, Arnold, LGB, Lenz, Märklin=, Digitrax, etc.
4.9 Menu “LocoNet module”
In the Basic Settings menu of the Intellibox there is a menu option
for the programming of Uhlenbrock into LocoNet modules, e.g.
feedback modules or Switch control.
The modules are programmed via LocoNet Configurations Variables
(short LNCV's). The LNCV's determine the operation and function of
the modules and can have different meanings with the different
modules.
Refer to the respective operating instructions of the module for a
description of the individual LNCV's and the connections.
4.9.1 Programming the module address
If a model railway layout has several modules of the same type,
they all need a different module address for programming, so that
the centre knows which module is meant.
Each new module has a specific default address. This is
documented in the modules manual.
Programming LocoNet CV's
• Connect the module to the LocoNet correctly.
• Use the Intellibox m and M key, to enter the Basic
Settings menu
• Press D-key to scroll the to menu option "LocoNet Prog.".
• Press R-key to go to the submenu.
• Enter the module’s part number (in this case LISSY receiver
68610) and press the E-key.
• Enter the receiver’s address (e.g. 1) and press the E-key.