User manual

Intellibox Basic
35
5.1.3 DirectDrive
Take control of the locomotive, which last passed over a certain
LISSY receiver, by the push of a button on the controller without
having to enter its address.
5.1.4 Using the address memory
The Intellibox stores the address of the last locomotive controlled by
each of the control panels in its memory.
• Press [lok#/f+]
• Press D
The last valid address is displayed and is ready to be used.
5.1.5 Releasing a Loco address
If a vehicle that is being controlled by the Intellibox is to be
controlled by another device which does not have a method for
entering the locomotive address (e.g. Uhlenbrock FRED or Digitrax
BT-2), then it must be released.
Use the following procedure:
• Press [lok#/f+]
• Cancel the whole address with the C key
• Press [lok#/f+]
5.2 Switching Lights and Special functions
The light and special functions can be switched for locomotive and
function decoders, with the function keys.
Motorola decoders have 4 special functions, DCC decoders up to
10 000.
5.2.1 Switching Light function
The [f0/+8] key switches the light function of a decoder on.
Releasing the [off/f+4] key switches the light function off.
As long as the [off/f+4] key is kept pressed, the function is active,
even if the [f0/f+8] key was not with switched before hand, e.g. for
the operation of a telex coupling.
5.2.2 Direct switching of Special functions : to =
Keys : ; < = can be used to directly control these special
functions.
Each key press toggles the relevant decoder output, from “off” to
“on”, and vice-versa.
5.2.3 Direct switching of Special functions f5 to f12
In order to be able to switch the decoders special functions [f5] to
[f8] the [lok#/f+] and [off/f+4] keys used as shift keys. They must be
operated in quick succession.