User manual

Intellibox Basic
36
The following key combinations apply:
- [lok#/f+] + [off/f+4] + [f1] switches special function [f5]
- [lok#/f+] + [off/f+4] + [f2] switches special function [f6]
- [lok#/f+] + [off/f+4] + [f3] switches special function [f7]
- [lok#/f+] + [off/f+4] + [f4] switches special function [f8]
- [lok#/f+] + [f0/f+8] + [f1] switches special function [f9]
- [lok#/f+] + [f0/f+8] + [f2] switches special function [f10]
- [lok#/f+] + [f0/f+8] + [f3] switches special function [f11]
- [lok#/f+] + [f0/f+8] + [f4] switches special function [f12]
If an extended special function was changed the display indicates
the special function and its state (1=on, 0=off) are.
The confirmation is shown for approx. 2 seconds. During this time
the extended special functions in the range f5 to f12 can be
switched without having to press the [lok#/f+] key again.
5.2.4 Switching Special Functions with numerical Input
All special functions to 9999 can be switched by numeric input.
For this the [lok#/f+] key is pressed 2 times in quick succession. In
the display the following menu appears on the side of the control
panel being used:
Now the number of the special function can be entered with the
numeric keyboard. Subsequently the function can be switched on
with the [+]-key and switched off again with the D key.
The lower line of the display shows the state with a "1" for switched
on or "0" for switched off.
5.3 Changing data format of a locomotive decoder
The Intellibox is able to simultaneously control decoders with
different digital data formats (protocols) on the same layout.
It is possible to transmit a different data format for each individual
locomotive address. In this case it is necessary to define the
protocol for each locomotive. Section 4.7 describes how to
configure the Intellibox default protocol.
Tip