User manual

Intellibox Basic

appears raised above, as with the pairs of keys, with which the

lower (green) key was pressed last.

6.4 Selection of the Keyboard address

After a system reset, the red/green pairs numbered 1 to 8 in Figure

6.31 are assigned to devices with addresses from 1 to 8.

The key assignment can be changed by assigning a new address to

first key pair of the Keyboard.

Method:

• Press the M key repeatedly

Until the display reads “Keyboard Mode”.

• Press the m key

• In the display’s left column in which is also the input position of

this menu, indicates the turnout address, which is assigned to the

first pair of keys. The second column indicates the turnout

address for the eighth pair of keys.

The direct input of the value for the first key pair is done with the

numeric keyboard. Alternatively the value can be increased and

decreased with the [+] and D keys.

If the value for the first key pair is changed, the address for all 8

key pairs is also changed automatically.

The following will be the display if the first key pair has an

address of 17:

• Press the E key to confirm and return to driving.

The R and L keys can select the groups of eight 1-8, 9-16, 17-24

etc. for the key field.

For solenoid decoders addresses 1 to 320 can be used in Motorola

format and the addresses 1 to 2040 for DCC decoders.

6.5 Keyboard Table mode

In Keyboard mode the address of the solenoid device controlled by

the first pair of keys is specified and the following key pairs are

automatically assigned the following solenoid addresses.

In keyboard table mode on the other hand any desired address can

be assigned to a particular key pair.

If address 0 is entered when in Keyboard mode, Table mode is

selected. The display confirms activation of the solenoid address

table by showing the following:

Importan