User manual

Intellibox Basic

Use the “Read” sub-menu to read and display long addresses. The

read procedure is initiated by pressing the E key.

Take note that even during a read operation bit 5 of CV 29 is set to

1. From that moment on, it will no longer be possible to control the

locomotive with its CV 1 “short” address, unless you reset bit 5 of

CV 29 to zero.

Use the “Program” sub-menu for programming addresses greater

than 127. The programming operation is initiated by pressing the

E key.

The long addresses programming procedure changes the

decoder’s CV 17, 18 and 29. After programming a long address, the

“short” address in CV 1 and the consisting address in CV 19 are no

longer available. If you want to use these addresses again, you

must set bit 5 of CV 29 to zero.

After entering a long address bit 5 of CV29 back to zero if the

decoder is to use the short address in CV1 again.

8.4.7 DCC programming error messages

If the programming operation of a DCC decoder fails, the top line of

the display will show one of the following error messages:

• Error The read or write operations of a register or a CV has

failed.

• no loc No locomotive is present in the programming track, or

the locomotive has a defective electrical contact with the

programming track.

• short Short-circuit in the programming track.

• Danger Electrical contact between the programming track and

the main track.

• no pag The decoder doesn’t accept paged programming.

8.5 Programming of Motorola Decoders

The programming of Motorola decoders is described in the manual

of the respective decoder and carried out from the control panel.

8.6 Programming of mfx-Decoders

You can find a guide for the programming of mfx decoders on our

InterNet site www.uhlenbrock.de under Service-FAQ-Märklin

System.

Caution

Importan