User manual

Intellibox Basic
55
11.3 Connect as Auxiliary Device
The rails of the isolated track section are connected to terminals 3
and 4 of socket 1.
The auxiliary device has its own transformer, which is attached to
terminals 5 and 6 of socket 1.
The LocoNet B socket of the accessory equipment is connected
with the LocoNet B socket of the center.
For connection with the center a non-crossed LocoNet cable must
be used. For this Uhlenbrock LocoNet cables 62015, 62025, 62045
and 62065 are available.
If a crossed LocoNet cable (62010, 62020, 62040 and 62060) is
used the polarity is swapped in the booster circuit and a short circuit
will result when driving over the track isolation between the two
track sections.
A non-crossed cable 62025 is supplied with the equipment.
The LocoNet T socket, the socket for DCC boosters and the USB
connection can be used as usual for the connection of LocoNet
devices, DCC boosters and a computer.
Information on the LocoNet cables
In the crossed version pin 1 is connected to pin 6, pin 2 to pin 5 etc.
In the non-crossed version the pins are wired 1:1, thus pin 1
connected to pin 1, pin 2 to pin 2 etc.
Attention