User manual

Intellibox Basic
59
List of Special options
Special Option No. 25
In factory setting the Intellibox only sends a data format if a decoder with the appropriate
format is addressed and is still in the refresh cycle. Alternatively the Intellibox can be setup
so that this data format is constantly being output even if no address with this data format
was called before.
For example the malfunctioning of some Motorola decoders can be prevented this way
where they automatically switch into the analogue mode the instant they stop receiving the
Motorola signal.
The input value is calculated by the following table. The values of the desired options are
added.
Option Value
DCC signal only if required
permanent DCC signal
0
1
Motorola signal only if required
permanent Motorola signal
0
2
Example
If the Motorola signal is to be sent permanently and the DCC signal only if required the
input is calculated as follows:
DCC signal only if required value = 0
Permanent Motorola signal value = 2
The calculated sum (here 2) is entered as value for this special option.
Factory setting is 0.
Special Option No. 97
Determines the state of the Intellibox after switching it on.
0 = [stop] key is activated. The driving power is switched off.
1 = [go] key is activated. The driving power is switched on.
Factory setting is 1.
Special Option No. 810
Turnout address of the 1
st
key Pair of keyboard when starting
0 = table mode, adjustable over the special options 851 to 858 and 871 to 878
1-255 = turnout address of the 1
st
key pair of keyboard
Factory setting is 1.
Special Option No. 812
The address contains the feedback module which is shown in the display after switching
the Intellibox on. Possible values are 1 to 128.
Factory setting is 1.
Special Option No. 815
0 = Intellibox starts in Keyboard-Mode (Factory Setting)
1 = Intellibox starts in Monitor-Mode
2 = Intellibox starts in Programming-Mode
3 = Intellibox starts in LISSY-Mode