User manual

Intellibox Basic
60
Special Option No. 818
Pause at the zero position for DC controller in steps of (factory setting) 10ms.
Factory setting = 50 (0.5 s)
Special Option No. 844
The Intellibox Basic can be attached to another LocoNet center (Intellibox IR, Intellibox
basic or Twin-Center) as an auxiliary device.
0 = operates as center (factory setting)
1 = operates as auxiliary device
Special Option No. 851 to 858 and 872 to 878
In the keyboard table mode each individual pair of keys can be assigned any turnout
address in the address range 1 to 2000. Special options 851 to 858 and 871 to 878 are
assigned to the eight pairs of keys.
Special options 871 to 878 hold the two low order places of the decimal turnout address.
Special options 851 to 858 hold the two with high order places.
Note: Input value = desired switch address minus 1!
Example: Key pair 3 is to be assigned the address 2000.
First the input value is determined, i.e. desired switch address minus 1 (= 1999).
The two places with high order (09) are put in the special option 853.
The two low order places (99) in the special option 873.
Factory setting is:
Key pair
1 2 3 4 5 6 7 8
Higher order Address
0 0 0 0 0 0 0 0
Special Option Number
851 852 853 854 855 856 857 858
Lower order Address
10 20 30 40 50 60 70 80
Special Option Number
871 872 873 874 875 876 877 878
Address
11 21 32 41 51 61 71 81
Special Option No. 907
This sets the digital signal which the Intellibox transmits, if no locomotive is in a refresh
cycle, e.g. after switching on the layout before the first locomotive is called.
1 = Motorola
4 = DCC (factory setting)