User manual

Intellibox Basic
66
We recommend installing a switch in the yellow and red wires to the turntable decoder. The
switch remains open until the Intellibox has completed its boot up. Then it is closed and
the programming process can begin, as in the operating instructions of the turntable
described.
Add Key Function Add Key Function
225
red
green
Ends programming
Programming / Input
233
red
green
Rotates to segment #9
Rotates to segment #10
226
red
green
Cancels programming
Rotates 180°
234
red
green
Rotates to segment #11
Rotates to segment #12
227
red
green
Next segment clockwise
Next segment anticlockwise
235
red
green
Rotates to segment #13
Rotates to segment #14
228
red
green
Rotation clockwise
Rotation anticlockwise
236
red
green
Rotates to segment #15
Rotates to segment #16
229
red
green
Rotates to segment #1
Rotates to segment #2
237
red
green
Rotates to segment #17
Rotates to segment #18
230
red
green
Rotates to segment #3
Rotates to segment #4
238
red
green
Rotates to segment #19
Rotates to segment #20
231
red
green
Rotates to segment #5
Rotates to segment #6
239
red
green
Rotates to segment #21
Rotates to segment #22
232
red
green
Rotates to segment #7
Rotates to segment #8
240
red
green
Rotates to segment #23
Rotates to segment #24
The addresses of the functions of the Märklin digital turntable
Controlling the Märklin Digital rotary crane
The address of the digital rotary crane must be configured for the old Motorola protocol.
The crane’s functions, like turning the cab and raising/lowering the boom, are controlled
with the : and ; keys and the speed knob. The working lights and the magnet are
switched on with the f key and switched off with the o key.
If, in multi-protocol operation, the crane should not respond correctly, try changing its
address.
Controlling the Roco crane wagon (Digital DCC)
The address of the Roco digital crane wagon (40110 or 46800) should be configured for
DCC - 14 operating levels. The crane wagon uses one locomotive address. The different
functions are operated with the [function], [off] and [f1] keys and turning the corresponding
knob.
The decoder address cannot be read on the programming track. Should you program a
different address, you will get an error message, even if the programming procedure was
successful.
Emergency stop button in the Lenz Booster output
If you connect the Intellibox ground (connector #1,
pin #5) with the Lenz Booster short circuit signaling
line “E”, (connector #2, pin #3) with a momentary
switch, the Intellibox will shut off power to the track
and to all connected Boosters.
You can have a number of “emergency stop”
buttons, connected in parallel, spread along your
layout.