Safety data sheet

Page 4/9
Safety data sheet
according to 1907/2006/EC, Article 31
Printing date 19.06.2015 Revision: 19.06.2015Version number 2
Trade name: UHU greenit +150°C
(Contd. of page 3)
41.0.9
·
8.1 Control parameters
·
Ingredients with limit values that require monitoring at the workplace:
67-64-1 acetone
IOELV (EU) Long-term value: 1210 mg/m³, 500 ppm
AGW (Germany) Long-term value: 1200 mg/m³, 500 ppm
2(I);Y, DFG, EU, AGS
141-78-6 ethyl acetate
AGW (Germany) Long-term value: 1500 mg/m³, 400 ppm
2(I);DFG, Y
110-54-3 n-hexane
IOELV (EU) Long-term value: 72 mg/m³, 20 ppm
AGW (Germany) Long-term value: 180 mg/m³, 50 ppm
8(II);DFG, EU, Y
·
Ingredients with biological limit values:
67-64-1 acetone
BGW (Germany) 80 mg/l
Untersuchungsmaterial: Urin
Probennahmezeitpunkt: Expositionsende bzw. Schichtende
Parameter: Aceton
110-54-3 n-hexane
BGW (Germany) 5 mg/l
Untersuchungsmaterial: Urin
Probennahmezeitpunkt: Expositionsende bzw. Schichtende
Parameter: 2,5-Hexandion plus 4,5-Dihydroxy-2-hexanon (nach Hydrolyse)
·
Additional information:
The lists valid during the making were used as basis.
·
8.2 Exposure controls
·
Personal protective equipment:
·
General protective and hygienic measures:
The usual precautionary measures are to be adhered to when handling chemicals.
Keep away from foodstuffs, beverages and feed.
Wash hands before breaks and at the end of work.
Avoid contact with the eyes and skin.
Avoid direct contact with the chemical/ the product/ the preparation by organisational measures.
·
Respiratory protection:
Use suitable respiratory protective device in case of insufficient ventilation.
·
Protection of hands:
Protective gloves
The glove material has to be impermeable and resistant to the product/ the substance/ the
preparation.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the
degradation
·
Material of gloves
The selection of the suitable gloves does not only depend on the material, but also on further marks
of quality and varies from manufacturer to manufacturer. As the product is a preparation of several
substances, the resistance of the glove material can not be calculated in advance and has
therefore to be checked prior to the application.
·
Penetration time of glove material
The exact break trough time has to be found out by the manufacturer of the protective gloves and
has to be observed.
(Contd. on page 5)
ENG