Certifications 2

Page 4/10
Safety data sheet
according to 1907/2006/EC, Article 31
Printing date 18.02.2021 Revision: 10.02.2021Version number 9
Trade name: UHU plus schnellfest + sofortfest (Binder)
(Contd. of page 3)
51.1.22
·
8.1 Control parameters
·
Ingredients with limit values that require monitoring at the workplace:
The product does not contain any relevant quantities of materials with critical values that have to be
monitored at the workplace.
·
Additional information:
The lists valid during the making were used as basis.
·
8.2 Exposure controls
·
Personal protective equipment:
·
General protective and hygienic measures:
The usual precautionary measures are to be adhered to when handling chemicals.
Keep away from foodstuffs, beverages and feed.
Immediately remove all soiled and contaminated clothing
Wash hands before breaks and at the end of work.
Do not inhale gases / fumes / aerosols.
Avoid contact with the eyes and skin.
·
Respiratory protection:
Not required.
·
Recommended filter device for short term use:
Combination filter A-P1
·
Protection of hands:
Protective gloves
The glove material has to be impermeable and resistant to the product/ the substance/ the
preparation.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the
degradation
·
Material of gloves
Hand protection Material : butyl-rubber (e.g. Butoject 898: material thickness 0,7 mm)
Break through time : > 8 h
Material : Ethyl Vinyl Alcohol Laminate (EVAL)
Break through time : > 8 h
glove material for short-term use / splash: (10 min <BTT <480 min): nitrile rubber, neoprene rubber
The selected protective gloves have to satisfy the specifications of EU Directive 89/686/EEC and
the standard EN 374 derived from it. Gloves should be discarded and replaced if there is any
indication of degradation or chemical breakthrough. Take note of the information given by the
producer concerning permeability and break through times, and of special workplace conditions
(mechanical strain, duration of contact). The suitability for a specific workplace should be discussed
with the producers of the protective gloves.
·
Penetration time of glove material
The exact break through time has to be found out by the manufacturer of the protective gloves and
has to be observed.
·
Eye protection:
Tightly sealed goggles
(Contd. on page 5)
EU-EN
62981 - UHU plus sofortfest 35g/30ml BL DFI
www.uhu.com 4/18
UHU plus sofortfest 35g/30ml BL DFI