Safety data sheet

Page 2/5
Safety data sheet
according to 1907/2006/EC, Article 31
Printing date 19.06.2015 Revision: 19.06.2015Version number 9
Trade name: UHU Klebepatronen Hot Melt
(Contd. of page 1)
41.0.9
*
SECTION 5: Firefighting measures
·
5.1 Extinguishing media
·
Suitable extinguishing agents:
CO2, powder or water spray. Fight larger fires with water spray or alcohol resistant foam.
·
5.2 Special hazards arising from the substance or mixture
No further relevant information available.
·
5.3 Advice for firefighters
·
Protective equipment:
No special measures required.
*
SECTION 6: Accidental release measures
·
6.1 Personal precautions, protective equipment and emergency procedures
Not required.
·
6.2 Environmental precautions:
No special measures required.
·
6.3 Methods and material for containment and cleaning up:
Send for recovery or disposal in suitable receptacles.
·
6.4 Reference to other sections
See Section 7 for information on safe handling.
See Section 8 for information on personal protection equipment.
See Section 13 for disposal information.
*
SECTION 7: Handling and storage
·
7.1 Precautions for safe handling
No special measures required.
·
Information about fire - and explosion protection:
No special measures required.
·
7.2 Conditions for safe storage, including any incompatibilities
·
Storage:
·
Requirements to be met by storerooms and receptacles:
No special requirements.
·
Information about storage in one common storage facility:
Not required.
·
Further information about storage conditions:
None.
·
Storage class:
13
·
7.3 Specific end use(s)
No further relevant information available.
*
SECTION 8: Exposure controls/personal protection
·
Additional information about design of technical facilities:
No further data; see item 7.
·
8.1 Control parameters
·
Ingredients with limit values that require monitoring at the workplace:
Not required.
·
Additional information:
The lists valid during the making were used as basis.
·
8.2 Exposure controls
·
Personal protective equipment:
·
General protective and hygienic measures:
The usual precautionary measures are to be adhered to when handling chemicals.
·
Protection of hands:
Heat protection gloves
The glove material has to be impermeable and resistant to the product/ the substance/ the
preparation.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the
degradation
·
Material of gloves
The selection of the suitable gloves does not only depend on the material, but also on further marks
of quality and varies from manufacturer to manufacturer.
(Contd. on page 3)
ENG