Instructions / Assembly

4LT PENDANT LIGHT
ASSEMBLY/INSTALLATION INSTRUCTIONS
installation.
shock.
All electrical connections must be in accordance with local and National Electrical Code (N.E.C.)
standards. If you are unfamiliar with proper electrical wiring connections obtain the services of a
referencing the illustrations on the installation instructions.
Phillips screwdriver , pliers.
CAUTION
GENERAL
TOOLS REQUIRED
ASSEMBLY AND INSTALLATION
ASSEMBLY AND INSTALLATION
(CONT.)
Turn off the power at fuse or circuit breaker.
Turn on the power at fuse or circuit breaker.
IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN.
2. Choose the length of the CHAIN you need, then weave the FIXTURE WIRE and the FIXTURE GROUND
4. Pull out the SUPPLY WIRES and SUPPLY GROUND WIRE from the JUNCTION BOX. Make wire
connections using the WIRE CONNECTORS:
---Attach the FIXTURE GROUND WIRE to the MOUNTING BRACKET with the GREEN GROUND
SCREW.Then connect it to the SUPPLY GROUND WIRE with a WIRE CONNECTOR.
Carefully put the wires back into the JUNCTION BOX.
Please read carefully and save these instructions, as you may need them at a later date.
WIRE through the CHAIN and CEILING PLATE.
3. Open the top and bottom section of the CHAIN using a phillips screwdriver (not included) and pliers
(not included), then attach it to the FIXTURE FINIAL. Close the CHAIN.
A
B
C
6. Install BULB (not included). See relamping label at socket area or packaging for maximum allowed wattage.
1. Gently take all parts out of the package, lay them on a smooth surface, unscrew the BALL NUTS and the
FIXTURE SCREWS. Attach the MOUNTING BRACKET to the JUNCTION BOX using JUNCTION
BOX SCREWS.
5. Attach the CEILING PLATE to the MOUNTING BRACKET through SCREW HOLES as shown, and secure
it with BALL NUTS.