Instructions / Assembly

Wire
strippers
Ladder
Safety
glasses
Electrical
tape
Phillips
screwdriver
PliersFlat blade
screwdriver
CAUTION
◆ Inspect the wire insulation for any cuts,
abrasions, or exposed copper that may have
resulted during shipping. If there is a defect
in the wire, do not attempt installation.
◆ Before starting installation of this fixture or
removal of a previous fixture, disconnect the
power by turning off the circuit breaker or by
removing the fuse at the fuse box.
Bulbs
(not included)
*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED
EXPLODED PARTS INSTALLATION
STEP 1
Unscrew the ball nuts, and remove the rubber rings.
Detach the mounting unit from the back side of the canopy.
STEP 2
Attach the mounting unit to the junction box (not included) using
mounting screws.
HARDWARE INCLUDED
Fixture
Rubber Ring
Ball Nuts
Mounting Screws
Junction Box (not included)
Wire Nuts
Fixture Mounting Unit
Mounting Unit
Ball Nuts
Rubber Rings Mounting Screws Wire Nuts
GFCI
Canopy
Make the electrical connection from the junction box (not included) to the
fixture. Connect the ground wire to the mounting unit using the preinstalled
green ground screw. Next, connect the positive, negative and ground wires
with the supplied wire nuts. Secure with electrical tape.
STEP 3
White wire from
the fixture
Ground wire from
the Fixture
Black wire from
the fixture
Black or Red wire (hot)
from the junction box
White wire (neutral)
from the junction box
Bare or Green ground wire
from the junction box
*Green Ground Screw
*Sealing tape
(not included)