Instructions / Assembly

Bulb (not included)
Glass Shade
Socket ring
*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE
EXPLODED PARTS
Fixture
Ball Nuts
Socket
Rotary dimmer switch
Mounting Screws
Junction Box (not included)
Wire Nuts
Fixture Glass Shade Mounting Unit
Mounting Unit
Ball Nut Mounting Screws Wire Nuts
INSTALLATION
Wire
strippers
Ladder
Safety
glasses
Electrical
tape
Phillips
screwdriver
Flat blade
screwdriver
Pliers
CAUTION
◆ Inspect the wire insulation for any cuts,
abrasions, or exposed copper that may have
resulted during shipping. If there is a defect
in the wire, do not attempt installation.
◆ Before starting installation of this fixture or
removal of a previous fixture, disconnect the
power by turning off the circuit breaker or by
removing the fuse at the fuse box.
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED
HARDWARE INCLUDED
STEP 2
Make the electrical connection from the junction box (not included) to the
fixture. Connect the ground wire to the mounting unit using the preinstalled
green ground screw. Next, connect the live wire, neutral wire and ground wires
with the supplied wire nuts. Secure with electrical tape.
STEP 1
1. Unscrew the ball nut from the mounting unit.
2. Adjust threaded rod on mounting unit to allow fixture to rest
flush against the wall when ball nut is tightened.
3. Use the mounting screws to attach the mounting unit to the
junction box (not included).
White wire from
the fixture
Ground wire from
the Fixture
Black wire from
the fixture
Bare or Green ground wire
from the junction box
*Green Ground Screw
Black or Red wire
(live wire)
from the junction box
White wire
(neutral wire)
from the junction box
*Sealing tape
(not included)