Operation Manual

ULEAD VIDEOSTUDIO USER GUIDE
11
Checking the hardware setup
After connecting your digital camcorder to the computer, check if the device is
detected by your Windows system. If you installed an IEEE-1394 card on your
computer, check also if the card is detected.
To check if the IEEE-1394 card and digital camcorder are detected:
1. Insert your video tape into the camcorder
and switch it on. Make sure it is in playback
mode (usually named VTR or VCR). Check
your camcorder's manual for specific
instructions.
2. Open the Control Panel, then open
System: Hardware - Device Manager.
3. Make sure the following device names are listed in the Device Manager.
Connecting a 4-pin to 6-pin IEEE-1394 cable to a desktop computer
Connecting a 4-pin to 4-pin IEEE-1394 cable to a notebook computer