Instructions

11B2. The rst run wizard First use of your Ultimaker Original
8. If the printhead can’t touch the end stop,
don’t force it. Unscrew the end stop with the hex
screwdriver and move it a bit inwards the frame,
as indicated on the image.
9. Move the printhead to the left corner untill
you hear a click.
10. Now do the same with side front Y endstop.
11. Now do the same with side back Y endstop.
12. Next step is to click the top Z-end stop,
rotate the build plate screw or click it with your
screw driver/nger.
13. When Cura asks you to click the bottom
Z-endstop, use the hex screw driver to touch
and click it.