Instructions

12B2. The rst run wizard First use of your Ultimaker Original
14. In this step Cura will help you to level your
printbed. Make sure you choose the
[Connect to printer] button to perform this
action.
15. The printhead should have moved to its ho-
ming position in the front left corner. The print-
bed should have moved up almost or against
the nozzle.
Use the Hex screwdriver and a standard A4
piece of paper to level you bed. Slide the pa-
per back and forth between the nozzle of the
printhead and build plate as you screw or un-
screw with the screwdriver.
16. Make sure you feel a little bit of friction from
the paper, sliding between nozzle and build
plate.
17. When you are nished with this corner, select
the [Resume] button in cura. This will move the
head to the next corner. Repeat this step for all
corners.
18. Follow the instructions, when you have mate-
rial inserted your Ultimaker Original, you should
select the [Resume] button again and now your
Ultimaker printhead will heat up and print a
square in lines to show and check that your build
plate is level and the material sticks to the tape.
If the build plate is too far away from the nozzle your 3D-print might not stick to
the build plate. Equally, if you adjust the build plate too close to the nozzle, the
build plate can block the lament from extruding from the nozzle.
NOTE: If you have a heated bed installed follow steps 14a to 18a