Instructions

13B2. The rst run wizard First use of your Ultimaker Original
14a. In this step Cura will help you to level your
printbed. Make sure you choose the
[Connect to printer] button to perform this
action.
15a. The printhead should have moved to its ho-
ming position in the front left corner. The print-
bed should have moved up almost or against
the nozzle.
Use the buttons Up 0,2mm or Up 10mm to move
the platform up to the nozzel. Make sure the
Z-switch is triggered. The Up buttons don’t work
if the switch is triggerd.
16a. Press Resume and the bed will move up to
the Z-switch trigger position.
Now use the thumbscrew in the left corner to
move the bed up or down so it is just touching
the nozzle.
17a. When you are nished with this corner, se-
lect the [Resume] button in cura. This will move
the head to the next corner. Repeat this step for
all corners.
18a. Follow the instructions, when you have
material inserted your Ultimaker Original, you
should select the [Resume] button again and
now your Ultimaker printhead will heat up and
print a square in lines to show and check that
your build plate is level and the material sticks to
the tape.
If the build plate is too far away from the nozzle your 3D-print might not stick to
the build plate. Equally, if you adjust the build plate too close to the nozzle, the
build plate can block the lament from extruding from the nozzle.