Instructions
14B3. The rst run wizard Installing the llament.
B3. Installinglamentandthespoolholder
1. First rotate the the small black lever vertically
then pull it all the way up.
2. Now take the black feeder part and pull it
outwards, this gives you a better view how to
get your lament into the material feeder.
3. Now take the lament wire and guide it up-
wards between the two wooden plates and up
through the coupling.
4. Make sure you push the lament all the way
through to the end of the bowdentube untill you
can’t move it any further.
5. Now rotate the black feeder part back into
place. Apply some pressure so the lever can be
pushed back down.
6. Now you can easily rotate the black lever
back so that the material feeder places the right
amount of pressure on the lament.