Instructions

D2. Navigation and basic functionalities

1. When pressing down on the push wheel you will be presented with the follo-

wing screen where see the main menu of the controller. The arrow in front of all

the functions indicate’s whats selected

23D2. Navigation and basics functionalities Use of the Ultimaker controller display

1. When you have selected >Info screen (this could also be named >Watch) and push

down on the wheel you navigate back to the rst screen.

2. Via >Prepare -> you will proceed to the next sub-menu where you can nd a variety of

settings that can be used to prepare your Ultimaker Original.

>Disable steppers: With this function you will disable the steppers. This allows you to

move the printhead and printbed without the motor resistance

>Auto home: With auto home you sent the printhead to the auto home position. The home

position is in the front left.

>Set origin: Set origin will make your current position the 0,0,0 (home position)

[Optional >Move Z: This allows you to move the Z-stage up or down by turning the con-

troller knob. ]

>Preheat PLA: With Preheat PLA your hot end will heat up to 210°C

>Preheat ABS: With Preheat ABS your hot end will heat up to 240°C

>Cooldown: With Cooldown the temperature will drop to room temperature.

>Move Axis: With Move axis you will open another sub menu which allows you to move your

axis around. You can move the X, Y, Z and E (extruder) motor by clicking on the X, Y, Z and E in the

menu and rotate your button. Extruding will only work when your print head is at least 180°C