Instructions
E1. In General
To achieve the best results from your Ultimaker Original, some basic
maintenance is recommended. This chapter contains tips which helps
you to keep the Ultimaker Original running at it’s best.
Before you make a print a quick check is advised. A visual check is
recommended to see if there is not any:
- Old prints/objects on the build plate.
- Make sure no one can walk over, damage or pull out the power supply cable.
27E1. In general Maintenance for your Ultimaker Original
Updating rmware with USB cable
Every once in a while Cura will give you a notication that new rmware is availa-
ble. New rmware means that we have optimised the control of the electronics
which results in better print results and user experience. If you see this notication,
connect the USB cable between your computer and your Ultimaker Original and
follow the instructions in Cura.