Instructions

E3. The Heated build plate
After a lot of printing, The glass plate can get a little bit dirty and the excess glue
needs to be cleaned o. It is recommended to do this every once in a while.
1. Turn o the machine and wait for the printhead and printbed to cool down so
you won’t burn your hands.
2. Now carefully move the glass retainer clips all the way to the side. (use a screw-
driver as leverage.
3. To take the glass plate out of the machine move the front a little bit upwards
and then pull it towards you.
4. Clean the glass plate using some dishwashing soap and water.
29E3. The Heated build plate Maintenance for your Ultimaker Original
4. Reinsert the glass plate and do a quick check if the platform is still level.