Instructions

B1. DownloadingandinstallingCura
Before we start using the Ultimaker Original we need to install the soft-
ware to calibrate the machine. The preferred software for your
Ultimaker Original is Cura developed at Ultimaker. This software pack-
age prepares your 3D model into instructions that your Ultimaker uses
to produce an object.
1. The Cura software package can be downloaded
from the “Our software” section on our website:
www.ultimaker.com/pages/our-software
2. Download the latest version of Cura for your operating system. Our software is
available for, WindowsXP or newer, MacOS 10.6 or newer and Ubuntu Linux 12.10
or newer.
3. Open the installer and follow the directions to install the software.
4. After the installation the congura-
tion and calibration wizard will run.
NOTE: We keep on updating our software, so the
latest version that you have downloaded might be a
newer version than the one in this manual. This should
have no impact on the installation procedure.
8B1. Downloading and installing Cura First use of your Ultimaker Original