Instructions

Step 2: connecting the controller Assembling and connecting the Ulticontroller100
image 131: placing the button
6.7.2. Step 2: connecting the controller
To connect the Ulticontroller, perform the following actions.
1. Turn o the Ultimaker Original.
2. Disconnect the electronic cooling system.
3. Guide the cables through the hole in the BOTTOM panel.
4. Connect the cable
5. Place back the Electronics cooling system.
6. Put the Ulticontroller on the lower part of the FRONT panel.
7. Turn the power on.
8. Insert the SD-card.
5
Notice: check for firmware updates and information the Software
setup guide.
Congratulations! You are ready to print now.