Instructions

Step 1: Assemble the extrusion head housing Assembling the extrusion head 49
image 55: attaching the peek and the brass pipe through the aluminium plate
8. Attach the cartridge heater and the thermocouple through the
wooden part 8B, see image 56.
5
NOTICE: use the hole back RIGHT.
5
NOTICE: the cartridge heater is the small 6 mm cylinder with a right
angle.
5
NOTICE: the thermocouple is the small 3 mm cylinder with an
aluminium sleve.
image 56: moving cardrigde heater and thermocouple through the aluminium plate
and the extrusion head housing.