Instructions

Step 1: Assemble the extrusion head housing Assembling the extrusion head52
19. Move the wires of the thermocouple, the cartridge heater and the
small fan through the middle hole of the wooden part TOP, see image
61.
image 61: moving the wires of the thermocouple, cartridge heater and the small fan
through the wooden part TOP
(for action 20-22 see image 63)
20. Attach WHITE bowden tube clamp in the front RIGHT hole of black
injection moulded part.
21. Move the Thumb screws through the corner holes.
22. Attach the Thumb screws. Do not attach the Thumb screws too tight.
image 62: Attaching the WHITE bowden tube clamp and the Thumb screws.
5
NOTICE: keep a small gap between the wooden part and the
aluminium plate.
23. Move the bowden tube through the WHITE bowden tube clamp and
through the teflon tube.
5
NOTICE: use the end of the bowden tube which has no blue tape..