Instructions

Step 5: Applying tape to the bed Assembling the Z stage68
6.4.5. Step 5: Applying tape to the bed
The following parts are needed in this step.
Letter Description Qnty. Letter Description Qnty.
A
acrylic print platform 1
B
blue tape 1
image 88: parts needed for this step
To prepare the bed for its fi rst print, perform the following actions.
1. Remove the protection foil from both sides of the acrylic.
2. Put blue tape strokes on top of the surface, see image 89.
5
Notice: place the tape strokes next to each other, NOT over each
other.
5
Notice: place the strokes in the same directions as shown in image 89.
3. Cut the blue tape by running a knife through the length of the groove
that is engraved in the acrylic, see image 90.
4. Remove the excess part of the tape.
A B