Instructions

Step 3: clamp assembly Assembling the material feeder 81
5
Notice: because you have to push the spring, it can take some force.
5
Notice: the spring should stick out about 11mm.
5
Notice: If it is hard to reach. Try without the spring first.
image 107: placing the U-Bracket on the clamp assembly
The result must look like this, see image 108.
image 108: result after attaching the U-Bracket on the clamp assembly
(for action 9-10 see image 109)
8. Attach the clamp assembly with U-Bracket on the main body of the
drive mechanism.
Use ONE bolt M3 x 20mm and ONE lock nut.
5
Notice: do not screw too tight, the clamp assembly with U-Bracket
must be able to move.
5
Notice: make sure the lock nut is NOT placed on the side of the gear.
9. Connect the lever to the main body of the drive mechanism.
Use ONE bolt M3 x 20mm and a ONE lock nut.
5
Notice: do not screw too tight, it must be able to move.
5
Notice: make sure the lock nut is NOT placed on the side of the gear.