Instructions

Step 1: preparing the electronic cooling system Mounting the electronics circuit board 87
To attach the electronic circuit board, perform the following actions.
(for action 1-4 see image 116)
1. On the BOTTOM panel put four bolts M3 x 30mm from INSIDE towards
OUTSIDE.
2. Place the tube spacers over the four bolts M3 x 30mm.
3. Place the electronic circuit board over the bolts M3 x 30mm, on the
tube spacers.
4. Secure with four threaded spacers.
image 116: mounting the electronics circuit board
6.6.2. Step 1: preparing the electronic cooling system
The following parts are needed in this step.
Letter Description Qnty. Letter Description Qnty.
A
cooling fan 1
E
wooden electronic
panel
1
B
cooling duct sheet 1
F
bolts M3 x 30mm 2
C
blue scotch tape 1
G
bolts M3 x 12mm 5
D
wooden cover panel 1
H
hex nuts 3mm 7