Instructions

Step 7: mounting the electronics cooling system Mounting the electronics circuit board94
6.6.7. Step 7: mounting the electronics cooling system
The following parts are needed in this step.
Qnty. Description
4 bolts M3 x 10mm
To mount the electronic cooling system, perform the following actions.
(for action 1-4 see image 127)
1. Attach the bolts M3 x 10mm into the white threated spacers, but not
all the way.
2. Place the cooling assembly over the bolts M3 x 10mm.
3. Move the cooling assembly.
The bolts M3 x 10mm must end in the smallers parts of the slots.
4. Attach the bolts M3 x 10mm slightly more, till they touch the wood.
image 126: mounting the electronic cooling system
6.6.8. Step 7: strain relief
To achieve strain reliefs, perform the following actions.
1. Guide the cables (black cable and the white cables connected to the
extrusion) through the strain relief.
Tip: the strain relief is the strain relief plate on top of the extrusion
head.