Instructions

Step 1: assembling the Ulticontroller Assembling and connecting the Ulticontroller 99
image 129: mounting the display v 1.0 to the Ulticontroller FRONT
(for action 4-8 see image 131)
4. Turn the controller on its front.
5. Plug both of the PCB connector cables into the connectors.
plug cable 1 into connector 1. plug cable 2 into conncetor 2.
6. Place six hex nuts 3mm inside the slots of the Ulticontroller BACK.
Tip: Use tape to keep the hex nuts 3mm in position.
7. Attach the Ulticontroller BACK onto the Ulticontroller FRONT,
Use two bolts M3 x 10mm at the long sides.
8. Attach the side parts.
Use two bolts M3 x 10mm for every side.
image 130: mounting the back plate and the side parts
9. Put the button in place, see image 132.