AimTrak Playstation 2 User Guide http://www.ultimarc.
Table of Contents Contents...................................................................................................2 1. Introduction.............................................................................................2 2. Buttons and Wiring..................................................................................3 3. Setup Guide..............................................................................................4 3.1 A Note on Firmware......................................
2. Buttons and Wiring If you have the retail, pre assembled AimTrak lightguns (in the style of the Playstation 1 GunCon45 lightgun) then the button configuration is as follows; A Button B Button Trigger If you have bought the OEM electronics AimTrak kit then you will need to have wired up the Trigger, Aux and P1 connectors for the lightgun to work properly with Playstation 2.
3. Setup Guide 3.1 A Note on Firmware Firmware 8.11 was used to test the AimTrak on PS2. Previous firmware versions may not be compatible. Please contact Andy at Ultimarc with the details of your AimTrak device and the firmware version installed if your device does not work with PS2. 3.2 Initial Setup 1) Plug the AimTrak lightgun into USB port 1 on your Playstation 2. 2) Plug the LED strip into the second USB port and place it centred above your monitor.
4. GAMES 4.1 A Note on Playstation 1 Lightgun Games Unfortunately Playstation 1 lightgun games will not work with AimTrak. AimTrak connects through the USB port and therefore cannot emulate the original GunCon45 lightgun which requires to be connected through the Playstation 1 style controller port. 4.2 Playstation 2 LightGun Games The following lists the Playstation 2 GunCon45 and GunCon 2 compatible lightgun games.
5. Troubleshooting I can’t start the calibration process The default setting is to enable calibration by holding the trigger, on screen, for 5 seconds. Unfortunately we have discovered that calibration does not work 100% for all games, please check the games section above for games that have been tested so far. Please note that sometimes the calibration process may not work properly for some of the games listed as working.
