Operation Manual

UE Custom

24 English

TROUBLESHOOTING

1. To reset your buds to their original factory settings put

your buds in pairing mode by turning the buds off then push

and hold the center button for more than 4 sec until

you see alternating red/green LED.

2. While the LED is ﬂashing red/green

double tap the center button .

Upon successful factory reset, the LED turns orange and

your buds turns off.

LED

NOTE: Once your buds have been reset and you power on they will

automatically go into pairing mode.

Select “Forget” or “Remove” Jaybird Freedom from your device’s

Bluetooth menu and pair again.

FACTORY RESET

RESET

If your buds are not responding, connect the charging clip

and USB cable to a power source. This will turn your buds off

and perform a soft reset.