Instruction Manual

Smart Mini Sensor
(1) Open the lower cover of the main magnet, remove the
battery separator, and power on the product
(2) According to the operating instructions, first perform
the network access operation and then proceed to the
next step of installation
(3) Choose to install door and window magnets on doors,
windows and other scenes
(4) Peel off the 3M glue of the main magnet and the
secondary magnet of the door and window magnets, and
then paste the device to the selected position. It
must be ensured that the secondary magnet and the
main magnet of the device are next to each other when
the door/window is closed, as shown in the figure
below.
Note:
The installation distance between the main magnet and the secondary
magnet should not be greater than the detection gap, so as not to
affect the accuracy of door and window opening/closing detection.