Troubleshooting Guide

3.9 About

The About function allows viewing of some important information

such as serial number and software version number of the scanner.

1. From Main Screen (See Figure 3.1), use the Up/Down

scroll button and Left/Right scroll button to select About and

press the OK button; wait for the About screen to appear.

2. View tool information on screen.

3.10 Vehicle Coverage

The 60694 Scanner is specially designed to work with all

OBD II compliant vehicles, including those equipped with

next-generation protocol -- Control Area Network (CAN). It is

required by EPA that all 1996 and newer vehicles (cars and

light trucks) sold in the United States must be OBD II compliant

and this includes all Domestic, Asian and European vehicles.

customerservice@focus-ontools.com

1-800-348-5004

PAGE 1
3.9 About The About function allows viewing of some important information such as serial number and software version number of the scanner. 1. From Main Screen (See Figure 3.1), use the Up/Down scroll button and Left/Right scroll button to select About and press the OK button; wait for the About screen to appear. 2. View tool information on screen. 3.
PAGE 2
A small number of 1994 and 1995 model year gasoline vehicles are OBD II compliant. To verify if a 1994 or 1995 vehicle is OBD II compliant, check the Vehicle Emissions Control Information (VECI) Label which is located under the hood or by the radiator of most vehicles. If the vehicle is OBD II compliant, the label will designate “OBD II Certified”. Additionally, Government regulations mandate that all OBD II compliant vehicles must have a “common” sixteen-pin Data Link Connector (DLC).
PAGE 3
Operating Error If the Scan Tool freezes, an exception occurs or the vehicle's ECU (Engine Control Unit) is too slow to respond to requests. You need to do the following to reset the tool: 1. Reset the Scan Tool. 2. Turn the ignition off and wait for about 10 seconds. Turn the ignition back to on and continue the testing. Scan Tool doesn’t power up If the Scan Tool won't power up or operates incorrectly in any other way, you need to do the following to check up: 1.