Instructions / Assembly

ManualsBrandsUltra Play ManualsOtherUPlay Today Commercial Cumberland Gap Playground Anchor Bolt Kit

Issued/Revised:

05/06/13

RAIN WHEEL w/TUBE CLAMP 02-07-5022

uPLAY TODAY

800.458.5872

www.ultraplay.com

HARDWARE COMPLETE

Parts List

PART NUMBER

QTYDESCRIPTION

02-07-01431RAINWHEEL CLAMP

02-07-00941

PLASTIC INSERT

02-07-00951METAL BUSHING

02-07-00121RAIN WHEEL

02-07-00881YELLOW PLASTIC CAP

33-12-00351

33-11-0113*1M8 x 100mm (4") BHCS BOLT

33-11-0300*

M8 FLATWASHER

33-11-0500*3M8 LOCK NUT

33-11-0103*

M8 x 25mm (1") BHCS BOLT

33-11-0700*1CLAMP RIVET

Items listed below Hardware Complete line are included with Hardware Complete Number

Warning: During Installation, Hardware And Small Parts Are Choking Hazards For Young Children. Store

Unused Parts Appropriately Until Assembly Is Completed. Once Assembly Is Completed, Remove Any

Unused Parts From The Play Environment And Dispose/Save Them In A Secure Location. Any bolt end

protruding more than two full threads beyond the face of the nut causes risk of clothing entanglement.

Promptly cut-off flush, file smooth, and treat to prevent corrosion.

Unless Otherwise Specified, All Units of Measure are Each

Note: Peen Tee-Nuts and Flatwashers to match radius of pipe after assembly is complete.

Note: Loctite (supplied by others) should be used on any non-patch hardware.

INSTALLATION INSTRUCTIONS:

1. If Metal Bushing is not already in Rain Wheel, use a Hammer to insert into center hole of Rain Wheel from back side.

NOTE:

THE RAINWHEEL TUBE CLAMP SOCKET IS SHORTER (3/4" DEEP) THAN OTHER TUBE CLAMPS (1" DEEP). BOLT

WILL BE TOO SHORT IF THE WRONG CLAMP IS USED.

2. Insert M8 x 100mm B.H.C.S. Bolt into shaft of RainWheel Tube Clamp. See Detail 049.

3. Attach Rainwheel to Rainwheel Tube Clamp using Plastic Insert, Metal Bushing, Yellow Plastic Cap, M8 Flat Washer, and M8 Lock

Nut. See Detail 049.

NOTE:

MOUNT THE TOP EDGE OF TUBE CLAMP 34" VERTICALLY FROM BOTTOM OF PAINTED UPRIGHT

4. Attach Rainwheel assembly to Upright using M8 x 25mm B.H.C.S. Bolt and M8 Lock Nut. See Detail 030. (Do not install Clamp Rivet

until entire unit is assembled.)

5. Plumb and level entire assebly before tightening all fasteners. NOTE: Apply Loctite to threads of Bolts to prevent from loosening.

MAINTENANCE PROCEDURE:

Periodically check hardware for tightness, and tighten as necessary. Always check all parts for breakage or wear, and immediately

put equipment out of service until any faulty parts found are repaired or replaced. Also Check all metal parts for rust, paint loss and

touch-up if necessary with paint. Check for welded areas and verify integrity. Check periodically resilient surfacing for appropriate

depth and remove extraneous materials that could cause injury, infection, or disease. Maintain detailed installation, inspection,

maintenance, and repair records for each public-use playground equipment.