Instructions / Assembly

ManualsBrandsUltra Play ManualsOutdoorsUPlay Today Pike's Peak Commercial Playground In-Ground Footers Kit

Issued/Revised:

05/08/13

BONGO DRUMS 02-07-5024

uPLAY TODAY

800.458.5872

www.ultraplay.com

Parts List

PART NUMBER

QTYDESCRIPTION

02-07-00921

BONGO DRUMS BRACKET

02-07-00561

BONGO DRUMS TUBE CLAMP

02-07-00931

MOUNTING BAR

02-07-00141

BONGO DRUMS

33-12-00201

33-11-0103*4

M8 x 25mm (1") BHCS BOLT

33-11-0501*

1M8 BARREL NUT

33-11-0102*2M8 x 20mm (3/4") BHCS BOLT

33-11-0300*

M8 FLATWASHER

33-11-0500*

M8 LOCK NUT

33-11-0201*

M10 LOCKWASHER

33-11-0700*1CLAMP RIVET

HARDWARE COMPLETE

Items listed below Hardware Complete line are included with Hardware Complete Number

Warning: During Installation, Hardware And Small Parts Are Choking Hazards For Young Children. Store

Unused Parts Appropriately Until Assembly Is Completed. Once Assembly Is Completed, Remove Any

Unused Parts From The Play Environment And Dispose/Save Them In A Secure Location. Any bolt end

protruding more than two full threads beyond the face of the nut causes risk of clothing entanglement.

Promptly cut-off flush, file smooth, and treat to prevent corrosion.

Unless Otherwise Specified, All Units of Measure are Each

Note: Peen Tee-Nuts and Flatwashers to match radius of pipe after assembly is complete.

Note: Loctite (supplied by others) should be used on any non-patch hardware.

INSTALLATION INSTRUCTIONS:

1. Choose the appropriate Upright to receive Bongo Drums.

2. Insert Bongo Drums Bracket into Bongo Drums Tube Clamp and secure using M8 x 25mm B.H.C.S. Bolt and M8 Barrel Nut.

See Detail 054.

3. Attach Bongo Drums to Bongo Drums Bracket using Mounting Bar, M8 x 20mm B.H.C.S. Bolt, M10 Lock Washer, M8 Flat Washer,

and M8 Lock Nut. From underside of Bongo Drums attach Bongo Drums Bracket using M8 x 25mm B.H.C.S. Bolt, M10 Lock

Washer, M8 Flat Washer, and M8 Lock Nut. See Detail 003.

4. Attach Bongo Drums Tube Clamp to Upright using M8 x 25mm B.H.C.S. Bolt and M8 Lock Nut. See Detail 030. (Do not install

Clamp Rivet until entire unit is assembled)

NOTE:

PLACE TOP EDGE OF BONGO DRUMS CLAMP 28" FROM BOTTOM OF PAINTED UPRIGHT.

5. Plumb and level entire assembly before tightening all fasteners. Note: Apply Loctite to threads of Bolt to prevent from loosening.

MAINTENANCE PROCEDURE:

Periodically check hardware for tightness, and tighten as necessary. Always check all parts for breakage or wear, and immediately

put equipment out of service until any faulty parts found are repaired or replaced. Also Check all metal parts for rust, paint loss and

touch-up if necessary with paint. Check for welded areas and verify integrity. Check periodically resilient surfacing for appropriate

depth and remove extraneous materials that could cause injury, infection, or disease. Maintain detailed installation, inspection,

maintenance, and repair records for each public-use playground equipment.