Instructions / Assembly

Issued/Revised:

06/03/13

TUBE CLAMP 02-07-0039

uPLAY TODAY

800.458.5872

www.ultraplay.com

Parts List

PART NUMBERQTYDESCRIPTION

02-07-00391

TUBE CLAMP

Items listed below Hardware Complete line are included with Hardware Complete Number

Warning: During Installation, Hardware And Small Parts Are Choking Hazards For Young Children. Store

Unused Parts Appropriately Until Assembly Is Completed. Once Assembly Is Completed, Remove Any

Unused Parts From The Play Environment And Dispose/Save Them In A Secure Location. Any bolt end

protruding more than two full threads beyond the face of the nut causes risk of clothing entanglement.

Promptly cut-off flush, file smooth, and treat to prevent corrosion.

Unless Otherwise Specified, All Units of Measure are Each

Note: Peen Tee-Nuts and Flatwashers to match radius of pipe after assembly is complete.

Note: Loctite (supplied by others) should be used on any non-patch hardware.

INSTALLATION INSTRUCTIONS:

NOTE:

CLAMPS MUST BE ATTACHED TO COMPONENTS PRIOR TO ATTACHING TO UPRIGHT.

1. Attach Tube Clamp to Upright using M8 x 25mm B.H.C.S. and M8 Lock Nut. See Detail 030.

IMPORTANT:

HARDWARE INCLUDED IN COMPONENTS.

2. Once assembly is complete, plumb and level structure and tighten all fasteners securely. Drill Ø1/4" hole through the clamp and upright.

Insert Clamp Rivet into drilled hole and tap into place with hammer. See Detail 030.

MAINTENANCE PROCEDURE:

Periodically check hardware for tightness, and tighten as necessary. Always check all parts for breakage or wear, and immediately

put equipment out of service until any faulty parts found are repaired or replaced. Also Check all metal parts for rust, paint loss and

touch-up if necessary with paint. Check for welded areas and verify integrity. Check periodically resilient surfacing for appropriate

depth and remove extraneous materials that could cause injury, infection, or disease. Maintain detailed installation, inspection,

maintenance, and repair records for each public-use playground equipment.

030

TUBE CLAMP

(02-07-0039)

UPRIGHT

FINISHED ASSEMBLY

= INSTAL

LATION DE

TAIL

COMPONENTS SHOWN IN

HIDDEN LINES ARE SOLD SEPARATELY