Specifications

8.27 REPORT LUN (A0h)
LINKFLAGReserved = 0VU=011
Reserved10
(MSB)
Allocation Length
(LSB)
6
|
9
Reserved
1
|
5
Command Code = A0h0
01234567
Bit
Byte
Figure 149. REPORT LUN
The REPORT LUN command requests that the drive return the known Logical Unit Numbers (LUN) to the
initiator. The Report LUN command should always be available and is unaffected by any reservations.
The Allocation Length must be at least 16 bytes. If the Allocation Length is less than 16 bytes, the drive
will return in CHECK CONDITION status with Sense Key of ILLEGAL REQUEST and additional Sense
Code of INVALID FIELD IN CDB. If the Allocation Length is not sufficient to contain the Logical Unit
Number values for all configured logical units, the drive shall report as many logical unit number values as
will fit in the specified Allocation Length. This is not considered an error.
The Report LUN command will send the LUN List in the subsequent DATA OUT Phase. The format of the
LUN List is shown in the following table.
(MSB) LUN = 0
(LSB)
8
|
15
Reserved
4
|
7
(MSB) LUN List Length = 8
(LSB)
0
|
3
01234567
Bit
Byte
Figure 150. LUN Reporting Parameter List Format
The LUN list length contains the length in bytes of the LUN list that is available to be transferred. The
drive supports only one LUN. Therefore the LUN list length must be set to 8. The only supported LUN is
zero.
Ultrastar 146Z10 hard disk drive specifications
150