Specifications

10.4.6 INITIATOR DETECTED ERROR Message
An INITIATOR DETECTED ERROR message is valid after a COMMAND, DATA IN/OUT or STATUS
phase has occurred. If another phase has occurred, the message is rejected. Depending on the model,
the drive will optionally retry the previous phase if it is command or status. If this fails or the previous
phase was a data transfer the drive will generate a CHECK CONDITION status and a Sense key of
ABORTED COMMAND with additional sense code of INITIATOR DETECTED ERROR.
10.4.7 MESSAGE REJECT Message
The drive will take the following actions after receiving the MESSAGE REJECT message in response to
messages listed below.
DISCONNECT The drive is not disconnected but remains connected.
COMMAND COMPLETE No error, continue to BUS FREE.
IDENTIFY Command aborted - enter BUS FREE - Sense data set to MESSAGE
REJECT ERROR.
LINKED CMD CMPLT Command aborted - link broken - enter BUS FREE - sense data set to
MESSAGE REJECT ERROR.
MESSAGE REJECT Command aborted - STATUS phase executed with CHECK CONDITION
- sense data set to MESSAGE REJECT ERROR.
RESTORE POINTERS Command aborted - status set to CHECK CONDITION - sense will be set
with the error that caused the RESTORE POINTERS message to be
issued. (Assuming that error recovery is in progress)
SAVE DATA POINTER The drive will not disconnect from the SCSI bus and it will not be
considered an error.
No previous Msg MESSAGE REJECT message is returned in response to initiator's
MESSAGE REJECT message.
Ultrastar 146Z10 hard disk drive specifications
192