Instruction manual

Page 155
P707 Time Units
Select the Time Units to be used with the Volume Units to determine the
desired flow rate from the options below:
Option
Description
1= per Second
Flowrate will be calculated and displayed in
Volume
units/
Second
2= per Minute
Flowrate will be calculated and displayed in
Volume
units/
Minute
3= per Hour
Flowrate will be calculated and displayed in
Volume
units/
Hour
4= per Day (Default)
Flowrate will be calculated and displayed in
Volume
units/
Day
P708 Flow Decimal
This parameter determines the number of decimal places in the flow rate
reading during run mode. It can be set between 1 and 3. Default = 2
P709 Flow Cut Off
This parameter is used to select the minimum flow, in a % of flow rate,
which is to be totalised. Enter values in % of maximum flow. Default = 5%
Dimensions
P710 Dimension A
This parameter is used to enter dimension “A” of the Primary Measuring
Device, where applicable, see table below for further details.
P711 Dimension B
This parameter is used to enter to enter dimension “B” of the Primary
Measuring Device, where applicable, see table below for further details.
P712 Dimension C
This parameter is used to enter to enter dimension “C” of the Primary
Measuring Device, where applicable, see table below for further details.
P713 Dimension D
This parameter is used to enter to enter dimension “D” of the Primary
Measuring Device, where applicable, see table below for further details.